You may want to use a paper clip or small section of wire to jump over the contacts on the plug of the temp sensor. Harness side. This is done with the wire unplugged from the temp sensor. The wire that leads into the plug may be broken. If this dosent work cut the plug off and twist the wire togather. If the warning stops you found the problem.
A broken path can be bridged with a piece of wire, and if it isn't all surface mounted, a broken component can be de-soldered and replaced.
You have a broken wire.
No current will flow though a circuit which is broken.
A multimeter will help you find if the wiring circuit is broken.
Typically, USB ports are attached directly to the computer's motherboard (the circuit board) unless, for example, you have additional USB ports on the front of your computer (which may be connected by a wire, and in which case could be replaced). So no, USB ports are usually soldered directly onto the circuit board and cannot be replaced without professional repair.
You would know if the computer box does not respond to certain commands or buttons pressed. Car computer boxes are known to break, and they can be fixed or replaced.
Unplugged connector, failed injector, broken wire, bad computer.
In a series circuit, if the current is broken the flow of all electricity stops.
The cast of The Broken Circuit - 1915 includes: Helen Holmes as Helen
When a bulb fuses the circuit is broken if it is on a serial circuit. If the bulb is on a parallel circuit, only the fused bulb will go out, any other bulb would remain lit. On a serial circuit, until the bulb is replaced by a new one, the circuit is not able to be used.
how to fix broken concrete drive way be repaired or does it have to be replaced?
because the circuit is not a full circuit so it wont work!