Ethernet AUI
AUI cables have a D-type 15 pin connector. Pin assignments are as follows:Pin 1Control In circuit ShieldPin 2Control In circuit APin 3Data Out circuit APin 4Data In circuit ShieldPin 5Data In circuit APin 6Voltage CommonPin 9Control In circuit BPin 10Data Out circuit BPin 11Data Out circuit ShieldPin 12Data In circuit BPin 13Voltage PlusPin 14Voltage ShieldPins 7, 8 and 15 are not used.
Ethernet. The specific kind of ethernet, be it 10BASE-T, 10BASE-5, 10BASE-2, or others, depending on which transceiver you connected to the AUI port.
Depends on your wireless protocol vs your physical port speed. But typically, a wired connection is best if connecting to the same router.
Data Terminal Eqipment (DTE)
Ports on Cisco routers can be enabled or disabled by the router OS. "Administratively Up" simply means that the port has been enabled by the router's OS. If a port is enabled (Administratively Up) and the protocol is down, then there is a problem with communications over that port. Problems could one of many including; bad cable on the port, the far end device is down, the protocol configurations on the two connected device ports are not configured correctly to enable communications.
Yes, the Airport Extreme Base Station is a simulatneous dual band (2.4GHz and 5GHz) router with a USB port for networking external hard drives or other usb devices.
COM port is used to configure a router but you can also get a COM port to USB port adapter which can configure a router using a USB port.
It is a six port ethernet bridge with six computer capability networking.
A rollover cable is typically used to connect from a DB9 serial port on your computer to the RJ45 console port on the router. An RJ45-RJ45 rollover can be used from Aux port to Console port or from the ports on a 2509-RJ/2511-RJ to a console port.
There is no significant advantage, you would need a wireless networking card on the expresscard slot, usb port, or on the internal mini-pci express slots.
If you are refering to port 21 (networking) then it is the port used by the FTP process (File Transfer Protocol). The person may be referring to AspenTech ip.21 which is a process control historian. See related link.
Put the networkcable provided by the company that connects you to the internet into the WAN port of your Linksys router.With a networkcable connect any 3com switch port to any Linksys LAN port.
FastEthernet Port Serial Port
I haven't seen a router with infrared port, even if you have one you will not able to use internet because the protocol which is being used by infrared does not support internet calls.