0
Can a step down transformers be used to convert 240v 32amp to 120v 32amp?
Wiki User
∙ 14y ago
Yes, the capacity of the transformer, on the primary side, to handle 240 volts x 32 amps is 7680 VA. This will allow on the secondary side an output of, I = W/E, 7680/120 = 64 amps, well within the range you are looking for.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you take single phase of 120V with a hot wire and a neutral step up to 480v and then step down to 2 phases of 120V or do you have to input 2 phases of 120v to get 240V out?
Theoretically that can be done with transformers, but the power available would still be limited by the circuit breaker on the original 120 v supply.
Do step up-down transformers waste electricity when plugged-in but not in use - note this is not referring to AC-DC converters but transformers that change voltage between 110-120v to 220-240v?
yes -- the input current still runs in the primary coil.
If you have a 120V Sony stereo amplifier that you plugged into a wall transformer to step down from 240V in Denmark and it worked fine then zapped can you replace the fried component to accept 240V?
== == If you have to ask a question like this please do not open the cover of the amplifier.
How can you get 240V single phase power from a 240V 3 phase service Can you just connect to two poles of the 240V 3 phase service?
I'm sure this isn't what you want to hear, but you probably need to ask an electrician familiar with your service and what you want to connect. As a general answer, you can connect a 240v line to line resistive load like an electric water heater to any 240v source. If you also need the 240v to have 120v line to neutral, like a 240v electric stove that contains a 120v clock and oven light, then its possible if the 3 phase power is connected in a "high delta" configuration, and you connect to the correct leads. If you have a high delta service and want to ignore the 3-phase power service and wire most or all of the loads in the building as a single phase load, the utility may have to be consulted.
Can a 120V solid state relay stands 240V?
No.If you are looking of a relay that will allow 240V, many suppliers sell a SSR that will handle up to 280V AC. Most are triggered by 3-32v dc.Just google: solid state relay OR solid state contactor
How can you convert 240v to 120v for ac?
Use a step down transformer 240 primary to 120 secondary. You must know what the connected load (amps) is so that you don't overload the transformer. Small transformers are rated in VA.
Can 240V washer run on 120V outlet?
No.
120V light fixtures wall mounted you want to convert to 240V for a house overseas?
It will work it you use 240 volt light bulbs.
Can you run your neon sign of 120v 50hz 60hz 0.6a 7.5kv 30mA in an Australian 240v power outlet?
No. The neon sign is fed by a step-up transformer. Primary side 120V, secondary side 7500V. If you applied 240 to the primary side you would get 15000 volts on the neon tube. A flash over and then nothing. If you can find a transformer from 120V to 240V or 240V to 120V then you are good to go. Connect 240V to 240V side and you will get 120V out the other, connect the 120V side to the neon sign and you should have light. Transformer should be at least 100va. This will give you an output of .83 amps at 120V
You are building a new house and trying to decide between 120v and 240v which is better More practical?
In the US, both 120v and 240v will be needed for your home, as different appliances need different voltages. Your TV needs 120V, while your electric dryer and stove will need a 120V/240V supply. If you have an electric water heater, or central AC unit, they will need a 240V supply.
Why are you not getting 240v between the two hot wires?
Because they are "in-phase". In order to get 240v, you need two 120v Alternating Current lines that are 180° out of phase, that is, opposite phases. Only when one line is +120v and the other -120v will you see 240v between the wires.
Can you take single phase of 120V with a hot wire and a neutral step up to 480v and then step down to 2 phases of 120V or do you have to input 2 phases of 120v to get 240V out?
Theoretically that can be done with transformers, but the power available would still be limited by the circuit breaker on the original 120 v supply.
Can you convert a 120 volt Yamaha clavinova to 240 volts?
Electronic technician will convert in no time. You need 240v power transformer in place of same wattage 120V. Super easy.
Do step up-down transformers waste electricity when plugged-in but not in use - note this is not referring to AC-DC converters but transformers that change voltage between 110-120v to 220-240v?
yes -- the input current still runs in the primary coil.
If you put a 60W 120V bulb in a 120V lamp that has a transformer for 240V and plug it into a 240V outlet will it work or blow the circuitry?
Off hand no but your explanations are not clear as to who is doing what to whom,,
Can I use 120v 10a 1250 w cable for projector 110-240v power in India?
You can use 120v 10a 125w cable projectors 110-240v power in India.
You have 120v photo flash lights - how do you use them with 240v in Oz?
Power adaptors are readily available that plug into Australia's 240v outlets, converting to 120v. Find them in travel, luggage and electronics stores.
