Since Kerosene and oil are two different substances I would think not. I would NOT try experimenting though if you don't know what you are doing.
Yes you can; According to "FlashOffRoad" "Kerosene is routinely added to home heating oil, in large quantities. The furnace doesn't know, or care. The furnace oil pump does not have the same clearances (they are more crude, greater clearances, lower pressure...) and the kerosene won't hurt them. Most will (and often do) run on straight kerosene--here in NH, if the oil tank is outside, the mix will be either 50/50 or straight kerosene. Kerosene doesn't have the same heat values either, you won't get the same amount of power from a gallon of kerosene as from heating oil, or diesel fuel." See full article for more detail <http://flashoffroad.com/Diesel/DieselFuel/about_diesel_fuel.htm> Personally though, I wouldn't add more than 10 gallons per 275 tank full just to be safe.
I just had a service technician clean my burner in preparation for the winter. I showed him a product I had purchased at Home Depot called Hercules fuel oil sludge treat. It comes in a one quart container and you put a pint in for a 275 gallon tank just before a delivery. The technician said you would be better off adding one gallon of kerosene prior to the delivery. The kerosene burns hotter and is a higher grade of fuel than home heating oil. He said it would probably do a better job than the sludge treatment product and costs less.
kerosene is thick fuel. when it will pass through fuel injection left it sticky and there will be a very adverse effect on the piston.
Allmost allways add it to a full tank.
No. Drain the fuel tank and add a product such as Heet that will remove the left over moisture. If there is just a small amount of water, fill the tank with fresh fuel and add Heet.
IF the kerosene doesn't have the red dye added to it you can add It makes it burn a little hotter. should not harm the engine.
If you accidentally put kerosene in your gas tank, you should siphon the tank to remove as much of it as possible. Add about half a tank of gasoline, then run the car as normal. The car may act up some, and if it has too much trouble, take it to a mechanic right away, but otherwise the kerosene should burn up and not cause any real problems.
Drain the tank, change fuel filter, add correct fuel.
Fuel system cleaner should be added to your tank before filling up with gas.
Add fuel to the tank and charge the battery.
If it is a small amount of water add a can of Heet to the tank and fill it with gasoline. If it has allot of water you will need to pump all fuel out of the tank, add a can of Heet and fill the tank.
Add a fuel injection cleaner into the fuel tank or go to a garage that has a fuel injection service machine.