Yes, I can. Remove the plastic housing from the door with a screwdriver - it pops off/out. release the button/control housing allowing you to clearly see and work with the wiring harness. The button itself easily is removed from the harness connector [well it's not physically easy - you have to pull and rock it and watch the clasps meant to keep it in place.
When you have fully removed the 'button' you will have a connector with 7 wires - a clip - w 7 connecting points for the switch to slide in. Both ends are ground but connect a small piece of wire to Terminal 1 or the small black wire. Jump or connect the other end to terminal 3 [assuming skinny black wire on end is 1] Now with 1 + 3 connected or shorted - also connect with a separate jumber to terminals 3 + 4 - remember there are seven looking like this _ _ _ _ _ _ _. Short 1 and 3 and then short 3 to 4 giving power to motor with voltage polarity set for 'up'. IT's that simple. For Down - short same 1 +3 and then 4 + 5 as 'switch' giving power to lower window. Good Luck.
the frame that holds the window in is bent and you have to change the whole inside of the door not just the frame.
how do you change a brake booster valve to a 1998 Pontiac transport
How do yo fix a stuck driver side electric window on a 1998 pontiac firebird.
What causes a 1998 Pontiac transport to run hot and engine shuts off
3400 v6
The proper tire size for a 1998 Pontiac Transport is P205/70R15. This info is on a sticker placed on the driver's door jam.
The ECM on a 1998 Pontiac Transport with the 3.4 V6 engine is located on the passenger side. It is behind the glove box.
it is in the dash, passenger side.
Take it to a qualified mechanic
electric seat wiring
In the tank
If it looks the same it will probably work.