A lathe machine is specified by-
1.The maximum diameter of the workpiece that can be operated on the machine.
2.The distance between the headstock and the tail-stock of the machine.
3.The length of bed of the machine.
The LATHE MACHINE IS SPECIFIED BY
1. THE DIAMETER OF JOB CALLED AS SWING OVER BED.
2. THE LENGTH OF THE JOB THAT CAN BE TURNED CALLED AS ADMIT BETWEEN CENTER (ABC)
what is lathe machine in short answer
difference between lathe and drill machine doing full on piece of metal
Vertical milling machine is for cutting large pieces. The lathe cutting tool motion is perpendicular to the ground. They are said to Karosl lathe.
It can duplicate itself.
Milling in a lathe can be two things:A cutter is gripped in the chuck and a workpiece the the tool post. The work piece is then milled by using the feed on the lathe. Although it has been done, it is an unconventional method and is not recommended.A 3-in-1 lathe with a milling attachment as part of the machine used for milling a work piece.
non- examples of feed in lathe machine?
swing
There is no difference between a turning machine and a lathe. They are two names for the same kind of machine
what is lathe machine in short answer
difference between lathe and drill machine doing full on piece of metal
difference between lathe and drill machine doing full on piece of metal
Vertical milling machine is for cutting large pieces. The lathe cutting tool motion is perpendicular to the ground. They are said to Karosl lathe.
lathe machine, power depends on the size and power of electric motor and gearbox lathe.
The lathe machine is an ancient tool, dating back to approximately 1300 BC. It was first developed as a two-person lathe by the Ancient Egyptians.
By hand. You can achieve incredible accuracy by hand, it just takes forever. Also lead screws made on the new lathe will be better than the hand filed one and so on...
lathe machine hour
A lot.