answersLogoWhite

0


Best Answer

Typically a hole for a single handle shower valve can be easily created by a good 3 5/8" hole saw. If u are installing a 2 or 3 handle valve the hole is 1 1/8inch hole saw. Take care in using the hole saw. Please read all manufacturer directions before u install this valve.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How big a hole is needed for a shower valve?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Natural Sciences

How big is Neptunes Black hole?

Neptune does not have a black hole


How big is the hole in ozone layer near Antarctica?

The hole in ozone layer is pretty big. It has been shrinking however.


How big of hole for sparrow?

a lot


Where is the big hole in lacunosa town in Pokemon black?

The big hole is apparently the giant chasm where you find a level 75 Kyurem.


Can you survive a skydive with a hole in your parachute?

yes but it depends how big the hole is and if you have a back up parachute

Related questions

How do you replace a shower valve?

i would advise that you get some Teflon tape at the hardware store this will help seal the screws so water doesn't leak out when you turn it on. 1. first you need to unscrew the shower head off.2. then wrap the screw threads in the Teflon tape(this part can be a little tricky and if you know anything about telfon you can quess why).3. then just srcew they new shower head on but make sure you do it nice and tight. that's for your standard shower head but if you have one of those hose shower heads there some extra steps and a lot more teflon. 1. do steps 1-2.2. then but on the base that holds the shower head. 3. then wrap teflon on the part of the hose that goes in the base.4. put hose in base.5. attach hose to head then put head in base holder. That how you but on a new shower head.


Where is the PCV valve AMC 304 engine located?

the pcv valve is located at the gack of the intake manifold there should be a gromet at the back or a big hole if theres a big hole you also need the gromet and it connects to the carb and air cleaner. I hope this was helpful It's in-line in the hose on the back of the intake manifold.


Why does the big hole of ozone layer is in the antarctica?

The ozone hole is quite big. It is as big as Australia.


Were is the hole in the ozone and how big is it?

The ozone hole is over Antarctica. It is quite big


How big is the hole in the ozone layer above Antarctica?

The ozone hole is quite big. It is as big as Australia.


How big can a anas hole get?

big


How big is the Antarctic ozone hole?

The Antarctic hole is big enough. It is the size of Australia.


When did Battle of the Big Hole happen?

Battle of the Big Hole happened on 1877-08-10.


When was Big Hole National Battlefield created?

Big Hole National Battlefield was created in 1883.


How do you adjust Yamaha YFM 350 Big Bear valve?

Many bike owners find it easier to take it to a mechanic to get their valve adjusted. However, it is possible to do it yourself. You must set your engine at TDC on the compression stroke. You do this by inserting a small screwdriver in the spark plug hole. You will then be able to access the valve you need.


How big is the hole in the ozone?

The ozone hole is quite big. It will grow or shrink depending on CFC usage.


How big is Neptunes Black hole?

Neptune does not have a black hole