1. Locate the switch near the top of the brake pedal and take off the electrical connector.
2. Loosen the lock nut and unscrew the switch
3. Installation is the reverse of these steps.
4. To adjust the switch turn it clockwise until the plunger just touches the brake pedal, then turn it 1/2 turn more and tighten the lock nut.
Probably an improperly adjusted brake light switch, or a defective switch. The switch is a simple device mounted to the brake pedal - easy to check and easy to replace.
Check the brake light switch located on the brake pedal lever. If there is power to the switch but nothing coming out replace it. Did you check the bulbs? Is there power to the rear sockets?
It is a switch on the brake pedal which sends current to the stoplights in the rear.
how to replace the brake light switch at the pedal of a 2001 ford zx2
look on the brake pedal you will see a lil switch there that's the brake light switch
The brake light switch is behind the brake pedal.
brake light switch is mounted by the brake pedel remove lower panel above brake pedel and then you will see the switch should be able to turn the switch to replace
How do you replace the rear brake light bulb on a 2001 Honda civic?"
The brake pedal switch is bad. How do I replace it?
you can find the switch on the back of the brake pedal.
Under the brake paddle there is a switch. You pull the switch out and replace it with another one.
The brake light switch, on a Dodge neon, can be found under the dashboard just below the steering column. The brake light switch just unplugs. Unplug the switch and replace with a new one.