remove the back seat by prying up on the front of the seat cushion, you will then expose 2 nuts holding your seatbeilt latches. remove them, and the seatback should easily pull upwards. the hydraulic pump is right there in the center, if you want to access the hydraulic rams that raise and lower the top there are screws in the side trim panels that you have to remove, and there are push in holders in the trim panels and around the speaker enclosures there are more screws that you have to remove. you also have to remove the trim piece that runs from the front dash to the rear seat areas to access another push in holder. the panel should come off fairly easy if you have removed all the holders.
There is no trunk access through the seat on a Chrysler Sebring convertible.
It is behind the rear seat back. The seat has to be removed to access.
It is behind the rear seat. You remove the rear seat to access.
It is behind the rear seat. You have to remove the seat to access.
Fuel Pump is located in gas tank as a part of the assembly includes sending unit, fuel filter and pump Tank has to be removed to access.
It is between the rear seat back and the trunk. You have to remove the rear seat to access.
The shift solenoid B for a 1997 Chrysler Convertible is located inside the transmission. The speed sensor has to be removed to access the bolts to remove the cover over this shift solenoid.
Down the middle of the valve covers. On a V6 the intake has to be removed to access the rear three.
It is located in front of the left front wheel, inside the fender. You have to remove the wheel and fender liner to access.
Yes. The fuel tank must be removed to access the pump.
take the air cleaner box out and the drivers side head lite out and it is under them. It is easier to access by removing the fender liner in front of the tire.
The pump is behind the rear seat. You have to remove the seat back to access.