0
please tell me
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you replace the throttle cable to the gas pedal on a 1998 Honda Accord V6 3.0 Vtec engine?
The 1998 Honda Accord 3.0 liter engine does not have throttle cable. The automobile has throttle linkage. The linkage is connected at each end with a connecting bolt. Remove the connecting bolt to remove the linkage.
Where does the speedometer cable hook to on a Honda Accord?
The speedometer cable hooks up to the engine in a Honda Accord. This is how the vehicle is able to calculate speed.
How do you replace a speedometer cable in a 1996 Honda civic?
There is not speedometer cable on a 1996 Honda Civic. There is a throttle cable. Top replace this unhook it from the throttle body and gas pedal. Hook on the new cable to snake it through the firewall. Properly hook the throttle cable to the gas pedal and throttle body.
How do you replace a Honda Accord Lx 1995 clutch cable?
The 1995 Accord ghas a hydraulically operated clutch, notg a cable.
How do you disconnect the cable on the speedometer on 93 Honda accord?
I believe there is no cable to the center and speedometer
Is there a cable to the clutch of a 1996 Honda Accord?
No the clutch is hydraulic.
Where do they route the antenna cable in the 2003 2004 Honda Accord?
How do you change a choke cable on a 2000 Honda rancher?
How do you change the choke cable on a 2000 Honda Rancher?
Can your negative battery cable make it hard for a 93 Honda accord to accelerate?
No
What would cause my Honda rancher when you push the throttle down to spit and sputter?
Clean the carbeurator and lube the throttle cable.
How do you repair an AT selector cable on a 1990 Honda Accord 2.2 LX?
No repairing the cable. Replacement is the only option.
Why does Throttle stick on 1997 Honda Passport?
I had a stuck throttle on my 1996 Passport. The throttle cable had a piece of protective black rubber around the throttle cable between the outer cable covering and where the cable connects to the throttle body. The rubber had began to come apart and some of it was getting inside the throttle cable covering, causing the throttle cable to bind. I removed the rubber piece and cleaned out the cable by covering it with GOOF-OFF and then sliding the cable in and out until my cleaning rag was clean when I wiped off the cable. I did not replace the rubber piece and have had no problems since.
