0
Note:The drivebelt routing decal on the radiator shroud to help during drivebelt install * To replace the belt rotate the tensioner pulley clockwise to release belt tension * Remove the belt from the auxiliary components and slowly release the tensioner * Route the new belt over the various pulleys again rotating the tensioner to allow the belt to be installed then release the belt tensioner
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change a 97 Chevy cavalier timing belt?
there is no timing belt. it is a timing chain and doesn't need replacement unless it is damaged.
Change an alternator in a 97 Chevy Blazer?
Remove the alternator belt by loosening the tensioner pulley. Remove the wiring from the alternator. Remove the retaining bolts to the alternator. Reverse the process to install the new alternator.
Where is the belt tensioner on a 97 Oldsmobile Aurora in order to change the Alternator?
just above the alternator wheel. there is a square hole on the top side of the tensioner.
Is the alternator on a 97 located in the back on the bottom of the motor?
Look at accessory drive belt alternator is driven by this belt
Why is your belt squeaking on a 97 cavalier?
It needs adjusting or tightening.
Where is alternator in 97 explorer?
The alternator is bolted to your engine . It is one of the items that is driven by your serpentine belt
How do you change your oil in a 97 Chevy Cavalier?
how to i put it at on the Chevy cavalier 2.2 l
How do you change a timing belt on 97 Mitsubishi mirage?
what steps do i take to change a timing belt for a '97 mitsubishi mirage
Why does the belt break on Toyota landcruiser?
Why do my new ribbed belt break on my 97 land cruiser? Pulleys and alternator are new.
How do you stop 97 voyager belt squeal?
Change the belt
Where to find the alternator belt on a Mitsubishi Eclipse 97?
Alternator belt would be the serpentine belt.. the big one that goes around all the crap... The only other belt should be around the timing... and that should be covered by plastic.....
How do you replace alternator on 97 cutlass 3.1?
Disconnect the battery negative. Loosen the belt and remove it from the alternator pulley. Disconnect all wires from the alternator. Unbolt the alternator from the bracket. Remove the alternator.
