Lift the car, remove the car tires, remove the brake shoe/calipers and remove the old brake pads. Put in the new brake pads, replace the brake shoe/calipers, replace the tire and lower the car to the ground.
itsa stupid ugly!
I would suspect it needs lubrication.
There are three 10 mm bolts that hold it in place. Remove those, then slide the headlight out. Release the clips from the bulbs themselves. Then put the new one back in the same way you took the old one out.
look at it,, figure it out change the damm brake
To change the back brake on the 2000 FXD kindly refer to your user manual.
On mine grand am, there are two black taps to pull on, inside the trunk at the top, the left on if for the driver side back seat to pull down and the right for the right side
One lifts the car on a car jack, removes the tires, remove the brake shoe, remove and replace the brake pad. Then one has to replace the brake shoe in the correct position, then put the tired back on the car.
After you open the back hatch, you notice two compartments, one on each side of the hatch area, remove the panels to gain access to the bulbs.
On the top of the back window position in the middle .
I know it will feel like you're going to break it, but firmly pull and it will come off. Replace the bulb, snap it back on.
open the trunk and pull back the carpet and there should be black plastic knobs that are threaded on.remove those and those should allow u to remove the light assembly.than change the bulbs and and reinstall.
How do you change rear brake drum on a 2004 Chevy Venture?