0
since it is a carburated bike it will have an adjustment screw that presses on the arm of the carb where the throttle cable is connected. with the bike running turn the screw clockwise about 1/4 to an 1/8 of a turn until you reach about 900 to 1050 rpm. be sure to give the carb time to adjust after every turn of the idle screw. usually about 30 seconds to 1 minute.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change the starter on a 1987 virago motorcycle?
How do you change the starter on a 1987 virago motorcycle
1982 xv920 virago Yamaha oil capacity?
3.8 US quarts with a filter change, 3.2 US quarts without.
Specs on a 1982 Yamaha virago 750?
tire psi
What is the tire pressure for a 1982 xv920 Yamaha virago?
28 psi
What is the initial pilot screw setting on a 1982 virago 920?
2 turns out.
Where is the fuse box on a 1982 Yamaha virago?
they are under all the warnninging lights and nutral light
Oil Capacity 1982 virago 920?
Both the XV920J and XV920RJ hold a total of 3.8 qt. oil after a rebuild, or 3.2 qt for an oil change without filter change, or 3.3 qt for an oil change with filter change. (according to Clymer's repair manual) Jim
Do I need to bleed the air out when I change the oil in a 1985 Yamaha Virago 1000?
No.
Where is the oil filter on 1982 Yamaha Virago?
Should be located Behind the 3 bolt cover on the right front side of the motor
Where is the oil filter on a 1982 xv920 Yamaha virago?
Behind a plate that is behind the rear brake lever......held in by 3 allen bolts.......
Why is my Yamaha virago 535 not hitting top speed?
possible change diaphragms in both carbs.
How do you set the idle on a 1987 Virago 535?
Hey you need lift the engine up and underneath the engine and there wil be a cap it says idle you want to pull that off and turn the screw with a screw driver i had one of these very good vehicle. hope this helps
