Take off the tire for easy access ,loose the set nut on the peice your replacing but just a litte,take the nut off the tie rod end. Probably has a cotter pin you need to remove first "use a new one when putting back together if possible"take off nut that holds the end on the arm .have a loaner tool to remove the tie rod end or you can take two hammers and hit the topof both sides of the tie rod end at the same time this will pop loose tapered bolt going thru the hole .now hold the tie rod and turn of the end "counting" the turns and put the new one one the same number of turns.should eliminate the need for front end alighnment. Grease the new one if it has a greas zerk if not don't worry about it .turn the new one .place the end thru the hole and tighten very snug"remember it is tapered so tighten it good put in the cotter pin and bend it. Tighten the loking nut againt the new end you just put on .install tire don't forget to use a good jack stand
No
how due you vhange a inner and outer tie rod on a 2001 Chevy Monte Carlo
There is no such thing as a 2008 Monte Carlo, so the answer would be no.
Water pump removal chevy monte carlo 3.8
No
Yes
you have to change the ring and pinon gars
There will be no 2007 Chevy Monte Carlo. The Monte Carlo has been discontinued and 2006 was the last production year. There are 2007 Monte Carlo's. They may have been made in 2006 but there are 2007 models.
Where is the oil sending unit at for a 2005 chevy monte carlo
How do i replace the purge valve on a 1999 Chevy Monte Carlo
Chevy
On a 2000 Chevy Monte Carlo it is along the frame rail on the drivers side