I would take a few of the plugs out of the engine and check them for wear. You might not need to replace the plugs because of the efficiency of the electrical system. You might just need to clean your plugs and re-gap them. If you do need new plugs: go out and buy 16 brand new plugs for the car,, there are 2 plugs per cylinder. The parts store will have the info for the right size. Plugs in these cars should last a minimum of 25,000 miles. Get a proper plug socket and make sure your socket slides all the way down so you don't break the ceramic insulators. I like to rub a very very small amount of an anti-seize grease on the bottom of the plug's threads...it helps when you need to remove the plugs later. Always hand screw the plugs in as far as you can before using the socket on them. Again, spark plugs are fragile and break easily. If you're asking this question, I assume you're a newbie at this. Remove a plug wire at a time so not to cross wires...which is hard to do, but not impossible. And don't man handle the plug wires...they're silicone and can break easily, which will make your car idle like a tractor. And lastly, make sure the car is cold, otherwise you'll sear your hands.
16 spark plugs in s430 mercedes benz year 2002
How i can change the engine oil for my my mercedes benz 240c 2003?
The spark plugs on a 1998 Mercedes Benz E320 are changed by removing the cover plate, disconnecting the plug wires, and unscrewing the spark plugs using a deep wall socket. New plugs are then put in place and torque down to specifications.
where is the spark plugs located on a 1996 mercedes e320
The same way you gap spark plugs for any car that uses spark plugs.
6
It doesn't carry spark plugs but it has 6 spark plugs installed in the engine. The only internal combustion engine that does not have spark plugs is a diesel.
In the engine... If it is a a straight six. They run in a row. follow the spark plugs wires to them.
There are twelve spark plugs on these engines actually -two per cylinder.
$10.00
Replacing spark plugs is pretty simple. Disconnect the battery and the spark plug cables, and remove the old spark plugs. Put in the new spark plugs, reconnect the cables and the battery.
how many cylinders does it have? that's your answer