answersLogoWhite

0


Best Answer

Assuming you have binary components the McCabe Thiele Method should be used. Otherwise a process simulator such as Aspen, Pro/II, and/or KGTower should be used.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

12y ago

factors affect column design

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you design distillation column?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

What is an enriching section in a distillation column?

It is the top section of the distillation column. The section where the vapour leaves the column to the condenser.


What is the difference between a column constraint and a table constraint?

column constraint is for a single column. table constraint is for an entire table.


In distillation towers what does 'flooding velocity' means?

Generally: The flooding velocity of the column is the velocity of the vapor rising through the column at which the liquid on each stage is suspended. The flow of vapor up through the column will not allow the liquid to fall down through the column causing the stages to "flood".


What should you do if your kerosene flash is increasing in the column?

By flash, it is assumed you mean the amount flashed in the flash zone after entering a column. If the amount flashed is more than you desire, lower the feed temperature. If the feed is some amount of saturated liquid and vapor, you will want to increase the percentage of liquid fed to the column. This applies to a general distillation column with more flash than desired.If this is a crude oil atmospheric distillation column, and you are getting too much kerosene in a side draw, your cut point probably does not meet the required specification. In this case you will need to adjust your pumparound rates and/or increase the amount of reflux.


Define reflux ratio?

reflux ratio is the ratio of the quantity of distilled material returns to the column to quantity of distillate. One can operate the distillation column without calculating reflux ratio, but the main purpose of it is to improve the efficiency of the distillate.

Related questions

What is an enriching section in a distillation column?

It is the top section of the distillation column. The section where the vapour leaves the column to the condenser.


What is the best fractionating column for ethanol distillation using lab glass?

distillation column


When was Distillation Design created?

Distillation Design was created in 1992.


How many pages does Distillation Design have?

Distillation Design has 710 pages.


Why maintain distillation column and distillation drum pressure?

gnhxfgvj


What is the ISBN of Distillation Design?

The ISBN of Distillation Design is 0-07-034909-6.


What is fractionation column used for?

The fractionation column is used to separate components of a liquid by distillation.


What is a fractionating column?

This is an installation used for separation by distillation.


What is the condensed gas taken from a distillation column called?

The distillate.


What is a batch distilation column?

This is a distillation column that doesn't have a continuous feed. The material that is to be distilled will typically be in a round bottom still at the end of the column.


What is the name of the column used to separate crude oil into its various components?

Fractionating column. The process is fractional distillation


Does distillation reduce the ionic product of water?

i dont know if new improved distillation process have arrived but if you take the old plate distallition or packed column distillation process..then the answer to your question is NO.