When you say it bends crooked do you mean it goes -almost- flat? well if so, the silver plate that moulds the stapler has most likely been turned around. press it down and it should pop out and just switch it to the right way.
OR
buy a new stapler :p
the problem is that the top end becomes misaligned with the crimping plate and the staple does not hit the curve, but instead hits the top of the plate. I just fixed mine. There are two guides either side of the staple tray on the base. I put a piece if alum flashing over one of them to hold the head in the proper position and glued it so that the barrel was pushed back where it is suppose to be.
Or u can buy a new one.
Check out the top of the stapler where the staples are discharged. Use the pliers to pinch the staple and pull towards you, pulling the staple out of the stapler's nose. After that, reassemble the staple gun by putting the magazine back in and screwing in the screw.
you can't
Replace them.
5,000
just bend it back. duuh.
All navel piercings are crooked to some extent. Now if yours is completely lopsided then it would be best to take it out and get it repierced.
Yes, the name of a specialized dental surgeon is an orthodontics' dentist. It can fix your crooked teeth and makes you a brand new man(woman)
Let it heal over and have it redone by a more experienced operator.
pick out the staples. Open the stapler and slide the tension bar back. With the edge of a sissor or knife, carefully pry out the staples one by one. Since you are not worried about damaging the offending staples, pry away. When you have picked them all out, release the tension bar, load the stapler and resume operation.
no
Well, if it's the tire that's crooked you deflate it a bit, wiggle it into place, and inflate it again. If it's actually the rim that's gone crooked it's another deal entirely. Type "wheel trueing" into any search engine and see what oyu get.
you probably have a broken wire in the drivers door harness that is the one that gose from the body to the door that bends you can fix it but you have to run a new wire if you fix it where it bends it wont last check the powers and the grounds that is most likely the cause