There is probably a "short circuit" condition in that circuit in which the fuse is "blowing." The following discussion regarding fuses which continue to blow after replacement should help in understanding the issue.
Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, no one can identify the specific cause/defect which is causing your problem.
The following generic answer applies to any electrical circuit, whether in a vehicle, or in a building, or whether alternating current [AC] or direct current [DC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors. And in a worst case, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do, protect the conductors and components of the circuit which it serves.
The proper "fix" is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it. Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an oversized fuse would almost guarantee damage to the wiring and an electrical system fire.
Make sure you have the right key because the door key will turn the ignition but won't start the car.
Remove the rotors and take them to a machine shop for inspection. If there is not much damage they can be turned.
ignition switch
To adjust the rear brakes on the 2001 Ford Focus ZX3, first remember these brakes are self-adjusting. Drive the vehicle in reverse and press the brake a few times to clear the lines and set the calipers. Then, stop the car. Place it in park and pull the emergency brake. Pump the brake while the vehicle is turned off. You will feel the brake peddle stiffen.
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
I have a similar issue with my 2007 Focus SE hatchback. I believe it is related to the brake-shift interlock. I have played around with the e-brake and letting the car roll back in park until the transmission's park pawl is engaged, etc. If the shifter button will release without your foot on the brake, the key will not release from the column either. Of course, I'm assuming this is an automatic...
how change brake fluid . i have ford focus lx 2000.ans how change air filter.
How do you remove the brake light cover on a ford focus
On a 2001 Ford Focus : The brake fluid reservoir is used for the brake and clutch systems
learn how
why 2003 ford focus stall when air conditioner is turned on
http://www.ehow.com/how_4509339_replace-ignition-coil-pack-ford.html