0
It's in front of the glove box, remove glove box and unplug and test for voltage first on the blue/white wire and make sure it not just a bad fan switch, they go bad more than the blowers do. If voltage is there then reconnect and jumper the blue/black wire to ground, if it don't run then the blower is bad.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the blower motor located on an Isuzu Rodeo?
Behind the glove box or compartment.
Can you put Nissan Pathfiner motor in a Isuzu rodeo?
can you put a 3.3 out of a pathfinder in a isuzu rodeo
What would cause lack of power to the blower motor on a 1994 Isuzu Rodeo?
It is either the fuse or relay. also check the heater/ ac control switch.
What is the oil filter in an Isuzu rodeo?
On a 1997 Isuzu Rodeo, the oil filter is located on the bottom front of the motor beneath the fan.
Is the V-6 motor in a 1996 Isuzu Rodeo an interference motor?
YES!
Where is the blower motor resistor in a 1999 Rodeo?
Held in by two screws in a housing just to the left of the blower motor housing.
How do you remove and install blower motor on 1994 Toyota pickup?
how to install a blower motor for a 1994 Toyota pickup
How do you remove and install blower motor on a 1994 Toyota pickup?
how to install a blower motor for a 1994 Toyota pickup
Where is the transmission fluid fill on Isuzu rodeo sport?
it is on the underside of the motor.
Is Isuzu Rodeo 2000 3.2 v6 motor an interference motor?
Yes , according to the Gates website ( they make timing belts etc. ) the 3.2 liter V6 in a 2000 Isuzu Rodeo is an interference engine
Is the V6 motor in a 1994 Isuzu Rodeo an interference motor?
Yes , according to the Gates website ( they make timing belts etcetera ) The 3.2 litre V6 engine in a 1994 Isuzu Rodeo ( is an interference engine )
How to install blower motor?
Install Blower Motor 1999 Honda PassportThe blower motor is located under the glovebox on the passanger side. It is held on by three Phillips head screws. Unscrew the three screws and the blower motor drops out. Disconnect the wires to the blower motor using the quick disconnect. To install a new blower motor repeat the above listed steps in reverse order.
