Place towels or other cover on windshield to protect.
Open hood, unscrew hood support shocks from ball joints at hood.
Lower supports down toward headlights, out of way.
Raise hood, support against windshield, making sure towels protect glass.
Locate windshield washer hose at lower left of hood. Cut hose as close to hood as possible.
With assistant(s), hold hood vertical and peel back hood seal 3-4" on either side of hood to allow access to hinges.
Loosen 4- 5/16" bolts at hinges (2 on each side), making sure hood is held vertical and to keep weight from transferring to windshield.
Once bolts are removed from both sides, lower hinges towards headlights, out of way.
With a person on either side, lift hood straight up to clear windshield, then flatten horizontal and carry towards front of car.
Next remove the plastic retainers on the old hood where the shocks were screwed into. There is a metal snap ring retainer, pry it loose with a screwdriver or pliers and pull retainers off ball joint on hood.
Transfer hardware to new hood.
Installation is opposite of removal.
Check alignment of hood before full closing, you may need to loosen hinges and tweak hood to align properly.
in a 1997 Ford Taurus if you lift hood to disable alarm will the ignition shutdown and lockout automatically?
the relace switch by the pedels that says hood or a picture of a hood look
The diagnostic port on a 94 Ford Taurus is located under the hood near the firewall usually on the driver's side. Ford started producing the Taurus in 1985.
Most of them are in plastic boxes under the hood.
Under the hood
The mega fuse for a Ford Taurus is in the fuse panel on the passenger side under the hood. It is a factory specific fuse and will have to come from a Ford dealer.
where is the fuel filter on a ford taurus 2001?
Under the hood in Power Distribution box above the fan by the hood latch
pry bar and duc tape
Passenger side, under the hood on the firewall.
On a 1998 Ford Taurus : The power distribution box ( which is " live " ) is located at the front of the engine compartment , near the battery
You have to install a new belt tensioner.