sears parts dept... www.sears.com in the parts section...or bring a model number to sears parts center and order.
http://www.dslreports.com/forum/remark,15171433
If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.
The duration of Switch - TV series - is 3600.0 seconds.
A stop switch is wired in series with the power supply and the load.
Switch - TV series - was created on 1975-09-09.
Switch - TV series - ended on 1978-07-09.
Check
usually in series
An AC wall switch is in series within the parallel circuit of the overall house wiring.
The KILL switch is in series with the ignition switch. When the KILL switch is open, the bike will not start.
The B.O.O. switch or Brake On/Off switch is located at the top of the brake pedal assemble.
The number one cause of intermitted gauge failure, acompanied by a no start is the ignition switch. The switch is a known issue with the second generation s/t series vehicles, and of those years 1997 was by far the worst. From my experience troubleshooting them, nearly 90% of 1997 Blazers, Bravadas, Jimmys, S10s, and Sonomas have needed an ignition switch replacement for various reasons. The switch can cause issues with anything routed through it, another one of the more common problems that can be caused by the switch is erractic/intermitted transmission shift problems. I will attach a link to the replacement procedure. Look for "Ignition Switch Replacement" in the links to the right.