Wax, a "Mothers" powerball, & microfiber towel. Put wax on powerball, buff toolbox using light pressure till no wax is seen. Use micro towel to wipe any access wax that may be left. This does not work so well on "Silver" diamond plate. Hope this helps!
diamond plate is a brand.
Diamond Plate was created in 2007.
You pour coca cola on the plate and use a cloth to rub the plate.
Diamond will not leave a streak on a porcelain streak plate because diamond is harder than the streak plate. It will leave a scratch on the streak plate for the same reason.
well first of all diamond can't be made into a plate because of a diamond is on a scale of 10 on the mohs hardness scale. Plus we dont have the weight or heat to cut a diamond UNLESS the machine is diamond tipped. You know the steel they make fire engine bumpers out of? That's diamond plate. To make a long story very short, how you cut diamond plate depends on what it's made from, but it cuts like flat plate does.
there isn't a aqua plate it is a splash plate, you find it underground
it's ZAP PLATE and you find it underground
underground
It is called a fist plate, search for it in Route 215.
Yes, in the old chateau, but it is called the "insect plate".
Black plate refers to the original license plate that was assigned to a CA car. The plates were black with yellow numbers and letters.
first, buy white and black nail polish, then start off with a black line, then white line, then black line, then white line, etc. -------------------------------------------------------------------------------------------------------------- Actually.. i am a nail polish lover and that advice is not enough.^ if you want it to be black and white zebra then ok, so after you have your black and white nail polish, what i do it get some tooth picks and something you can put nail polish on like a plastic plate. then, what you do, is paint your whole nail black. after it drys, you migh want to put another coat on. just in case it isn't dark enough or you can see your nail through it. ok and after it drys, dump some white nail polish on the plastic plate. grab a tooth pick, stir it around in there and apply it in a straight horizontal line starting from the side of the nail. then do it again a little bit lower but on the other side of the nail. make sure you don't have too much white nail polish on the tooth pick. change out the tooth pick if it gets too old. and after you do this to both hands, it should turn out really good(: hope this helps!