How do you program a Sharp television with a Zenith universal remote?
You can program a Zenith universal remote control to use with a Sharp TV by entering in one of the following codes. The codes are 1004, 1006, 1012, 1026, 1029, 1095.
1 person found this useful
Without knowing the remote model number, I would do this: To do a brand code search for Sharp: Manually turn on the TV. Hold down the "TV" button on the remote....while holdin…g it down also hold down the On/Off button on the remote for 3 seconds. Release both buttons. Press the number 6. The TV light on the remote should blink once. Press the On/Off button on the remote repeatedly until the TV turns off. When the TV turns off, press the STOP key on the remote to save the code. That should be it.
If your instructions aren't available, use the link to Thompson's instructions for the RCA remote.
You need to use the pamphlet that came along with the remotecontrol. You need to put in the code number for your TV.
Well the same thing happend to me cause well the remote "flew" out of my hand so i bought a GE universal remote, it works terribly, u have to hold down a button for three seco…nds to turn one channel and to turn the tv on and off...it may be the remote but im gonna try again....so hopefully this helped you!
some codes that have worked for me are 520, 904, and 906. Hope this helps got these from:UNIVERSAL REMOTE CONTROL CODE LIST
Hi Dear, These are the codes fore sharp TV 011,,034,049,058,181,20,216,226
You can use the Code Search function to find the code. Hold Code Search for a few seconds until the light stays on. Then press the TV button. Point the remote at the TV and… press the Channel+ button until the TV changes channels. There are up to 300 codes so you may have to press Channel Up a lot before it works for your TV. Make sure you stop pressing Channel+ as soon as the TV changes and press the Ent key to lock in the code.
What are the codes to program a zenith mbr3455 universal remote for a zenith DVD player
I have a friend who was named after this TV set. So I feel qualified to answer. The answer is never.
there is no cable button on this remote what do i push to hook cable its says hit cable button
i have hct tv model HPP_42HCB i need the code for the remoteDirectv remote rc65rx
If you have a Zenith television, no remote control can help you.
The steps to program a remote to a TV are below! Addressing Remote to TV: 1.) Press and hold the clear TV button until all mode lights light up. 2.) Release and TV lig…ht will be blinking. 3.) Enter code and press #. The TV button should flash 3 times. 4.) Try functions (Volume, Power, etc..) and see if it is working. 5.) If no function, repeat steps 1-4 with another code.
Go to Jupiter to find out
The Sharp TV remote codes for a RCA universal remote are either 01 or 02. The exact code will sometimes depend upon the exact model of a person's TV.