1st remove the pully then you will see the bolts to remove the housing good luck
Replace belt tensioner. Three 13mm bolts in a triangular pattern, after you remove belt of course
I'm not a mechanic but I just had to have the belt tensioner replaced on my 99 ZX2. There are no other adjustments.
you might want to try and change belt pully tensioner
The correct belt tension will be maintained by the belt tensioner. The tension is not adjustable on this car.
short answer: just above the ac pulley long answer:http://www.rldassociates.com/zx2/howto/belt.htm
Replace the tensioner pulley
http://www.clubfte.com/users/racerguy/zetecbelt.gif number 5 is the tensioner
Release the tension by applying a 3/8 inch ratchet into the tensioner bar. Pull it towards you and take off the belt.
1. Loosen the tensioner with a 3/8 inch ratchet in the hole and pull back. 2. Take the belt off the tensioner. 3. Take the side bolt going into the head off. 4. Take the tensioner off.
take belt off. remove motor mount above pully jack up motor you will get just enough room to work bolt out towards ft.
belt answer
every easy!!!!!!!!!!!!!!!!!!!! you just need a 3/8 rachet or a breaker bar to remove it ( it has square, there put the 3/8 rachet and move the rachet to you and the tenssion will be rerove and it will come out easy as a piece of cake Here is a page that has a picture and detailed instructions. http://www.rldassociates.com/zx2/howto/belt.htm THIS WILL HELP!!! here are a few key words to help other people to find this site zx2 belt zx2 serpentine belt zx2 v-ribbed belt escort zx2 serpentine belt how to install zx2 accessory belt