0
How do you remove the lash from a 2001 2500 Dodge 70 series rear ring pinion?
Wiki User
∙ 15y ago
There are adjusrers on the sides of the ring gear housing for side clearance and the pinion gear depth is achieved by removing pinion gear and adding or removing shims to correct depth. should be done by an experienced technisian.v After the pinion depth is set(with shims). The backlash is set with shims under the side bearings.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you remove the radio in a 2001 dodge caravan sport sport?
Go to the dodge place and ask THEM to remove it
How do you remove the door panel of a 2001 Chrysler sebring?
how do you remove the door panel on a 2001 dodge stratus?--2 door
How do you remove the top piece of the dash from a 2001 Dodge Ram?
== ==
How do you remove the fan clutch on 2001 dodge durango?
Axe?
How do you remove a 3.3 from a 2001 Dodge Grand Caravan can it come up and out?
no? dodge recommends lowering it out of the bottom.
Remove 2001 dodge caravan lock cylinder?
do you mean the door or ignition?
How do you remove drivebelt dodge ram 2001?
use a ratchet to pull be on the belt tensioner to loosen slack then remove the belt
How do you fix leaking rear axle on 2001 ford expedition?
Pinion seal: Remove the drive shaft from the yoke. Pull the pinion yoke off the pinion shaft. Remove the old seal and hammer on a new one. Seal is about 10 bucks. Re-assemble Rear cover: Remove the cover bolts. Put a pan under the rear end and pry the cover off. Clean and re-silicone the cover Re-assemble. WARNING!!!!! Don't let the rear end run dry, will cost you pinion bearings in a very short time.
How do you remove the PCV valve on a 2001 Dodge Stratus?
What size motor 2.4, 2.7, 3.0 ?
Where is transmission filter on 2001 dodge stratus located?
Inside the transmission, remove pan to access.
Where do you drain transmission fluid out of a 2001 dodge stratus?
You have to remove the oil pan to drain the fluid.
How do you remove ac lines on a 2001 dodge ram 2500?
The 2001 Dodge Ram 2500 air conditioning lines are held in place with swivel nuts at each end of the hose. Turn the swivel nuts to the left to remove the air conditioning hoses.
