Check out: www.innovativepipeliners.com
That depends upon where it is located. If underground you first have to make sure of the exact location of the leak. Then you have to get to it. If at the pool equipment pad then remove the leaking pipe or fittings and replace them with the same materials.
Pipe sealant that is often used as a boiler repair by Hercules chemical corp
Drain the water to below the level of the leak, and let it dry. Glue a patch over the hole, and let it dry according to the directions in the patch repair kit. Refill pool and enjoy swimming.
Unless you developed heroes or xmen powers,you have to dig.
Leak detection dye can be purchased at any number of pool repair/maintenance companies/websites; it can also be found on eBay. There is no powder you can put into a swimming pool to detect a leak.
You have a leak. You need to find and repair the leak.You have a leak. You need to find and repair the leak.
repair emission leak
Around 100$ to 300$ Depending on the roof and structure.
Unless you dug the whole line up you probably wouldn't find the leak unless it was a very large leak which would bring the water to the surface, You would be better off just installing a new line. Call a leak detection company. They will find your leak to within inches, and you will be able to dig down, repair the line where it is broken, and repair it.
What does it cost to repair a vaccum leak on a 2001 deville
Not currently anything on the market that is safe. Fill and clean your pool thoroughly, vacuum and call a swimming pool leak detection company.
I'm no expert, but here's an idea - turn off the filtration pump, and add some dye (maybe a lot?) to the water and follow the direction in which it flows - it should (eventually, I think) flow towards the leak.