You have to buy the wheel bearing assembly.
Yes it does. It has inner and outer bearings.
YES
Wheel bearings on 1995 Geo Prizms are sealed units and cannot be repacked with grease. You must buy new bearings to be pressed on hubs by mechanic with proper tools. If bearings are worn, replace ASAP before bearings start damaging hubs, you'll save bunches of money.
Front or Rear? Both
If it anything like the 1995 CC Sedan, you replace the whole front wheel hubs, rather than just the bearing. Its easier & cheaper after you take workshop charges / parts into consideration.
don't you have a manual that can help us?
I have a 2011 650i and it costs 1300 its prolly about that...
could be a tie rod
The rattling sound in the front of a 1995 Honda Civic wheels can be caused by wheel bearings. These bearing allow the wheel to turn and when they fail the produce a loud noise.
In most cases wheel bearings cannot be repaired and must be replaced. Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearings. Reverse the process to install the new wheel bearings.
You need to get the rotor off to replace studs with new ones.
WRONG......Front wheel bearing replacement or repack is a pain in the butt. Best left for a trained technician. The last time I took mine for a brake test, the mechanic told me Toyota does not make them with wheel bearings Of course the truck has wheel bearings. Pull off the brake calipers and rotors and the spindle nut and the hub should slide out of the backing plate the bearing should come out of the hub. Your bearings should come in a set with a race; the race will have to be pressed out of the hub and the new race pressed in. Put it all back how it came apart.