1. Jack up the front of the vehicle.
2. Remove the drivers side tire.
3. Remove the fender liner by pulling the retainer pins. (you might want to get some replacement pins since they often break)
4. Pay attention to the current routing of the serpentine belt; it can be confusing when you try to figure out where the new one goes. It might be a good idea to make a drawing of the current routing.
5. Release tension on the idler pulley. It's spring loaded and it might be a good idea to have someone help at this point.
6. While the tension is off, pull the old belt off one of the pulleys. (that's where the help is handy)
7. Completely remove the old belt then examine all of the pulleys. Especially check the idler pulley bearings (spin and listen for noise or roughness in turning), examine the power steering pump and water pump for leakage and check the alternator for noisy bearings.
8. Replace any faulty components.
9. Replace the belt in the reverse order.
10. Put the fender cover back on.
11. Put the tire back on.
12. Lower the jack.
carbertor
About $500 to $600 for the belt, and another $150 or so for the water pump.
what the torque spec for the cylinder head on a 2003 saturn L300
The L300 V6 holds 5 quarts of oil.
It just cost me $735 from a mechanic I have always trusted. I have a 2001 L300.
Approx. $1,000 USD from a Saturn dealer. You may want to also change the water pump at the same time.
pop the four clips on the air box and lift up to reveal air filter
Replacing the Saturn L300 fuel pump will cost approximately $450. The exact cost is dependent upon several factors, such as the rate for labor.
5w15
The correct transmission fluid to use in an L300 Saturn is Dexron III. The capacity for a complete change is about 6.75 quarts.
how do you replace head light blubs l300 panel van
it is located in the air tube connecting the air tube to the intake opening at throttle position sensor