The 1991 Geo speedometer cable is held in place with a swivel nut on each end of the cable. Turn the swivel nut to the left to remove the speedometer cable. Reverse the process to install the new speedometer cable.
The speedometer is cable driven.
A 1991 dodge dynasty speedometer bouncing could be a sticking speedometer cable, or a bad drive gear. Check the cable first, and lubricate it to see if the problem stops.
Yes , I BELIEVE the last year for a speedometer cable on a Ford Explorer was the 1995 model year so the 1991 Ford Ranger would definitely have a speedometer cable
The cable is manual drive on a 1991.It plugs directly in the back of the speedometer.
It does not have a cable... It is electronic controlled. It has a sensor that is bolted in the drivers side of the transmission TAIL SHAFT that controlls the speedometer among other things.
I've bee told that the 1991 model doesn't have a cable it works off the speed sensor.
Broken cable?
Im not sure if your vehicle has a speedometer cable or if its a digital type thing with all wires and an electric motor opperating your SpeedOMeter but if it is a cable driven one, then just disconnect the cable from the speedometer from inside the vehicle... raise the vehicle if needed, I think its easier to get it from top, if the vehicle has the A413 transmission, remove the 10mm bolt holding the Speed Sensor in because the SpeedOMeter cable is running threw the middle if it, it does have a round O Gasket on it so it will be tight removing it, but it will come out with alittle wiggle and install the new the same way as you took it off.
If it's cable driven, you probably need to replace the cable. Otherwise, if it's digital impulse driven, it's probably the speedometer itself.
My 1991 Geo Prizm LSI does not have overdrive My 1991 Geo Prizm LSI does not have overdrive
The speedometer cable (which runs from the transmission to the dashboard) has snapped. This is a two-piece cable, and the one-piece cable in later Proteges will not work. I had the transmission replaced, and the cable could never be fit in properly. This is a mechanical speedometer, so you would have to change the entire speedometer part of the instrument panel to use a magnetic/electronic speedometer.
Look up 1991 ford escorts manual transmission speedometer