To replace the starter motor on a Celebrity:
Remove the negative battery cable from the battery.
Raise the vehicle as necessary, place jack stands for safety.
Remove the wires from the starter solenoid. Make note of which wire goes where so you will know where to put them back.
There may be a rear support bracket, if there is remove it noting how it came off so it can be put back as it was.
Two 15mm bolts hold the starter to the engine block, use a suitable socket , extension and ratchet to remove them.
At this point the old starter will pull out of the bell housing.
Reverse the procedure to install the replacement starter.
There may be shims between the starter and the block. If there are be sure to put them back with the replacement starter.
The starter solenoid is located on the top of the starter.
No.
Are you asking about the starter solenoid? If yes it is on the starter. If you are not asking about the starter solenoid what are you asking about?
== ==
Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.
Disconnect the - battery cable Raise and support vehicle Disconnect the wiring at the top of starter Remove starter mounting bolts Remove starter
Probes were not made until 1989
You can replace the ignition control module and the crankshaft position sensor as required.
replace the starter
To change the dash light bulbs you must remove the instrument panel.
remove batt. cable from starter(its not wired to batt so has no power) remove 2 1/2 bolts remove starter
According to my factory service manual the horn relay for a 1989 Chevy Celebrity is located in the "convenience center" which is behind the instrument panel on the left side of the steering wheel. To replace the relay one would simply pull out the old relay and plug in the new relay.