If you are referring to the Malfunction Indicator Light (yellow engine shaped light) the simplest way is to disconnect the negative battery post for 20 minutes or so. If the light comes on again during vehicle operation then the cause of the fault has not been corrected.
The service engine light can be reset on your Jeep Commander, by switching the message center to the oil life message. Once on the message, hold the check mark until it returns to 100%.
How do you reset engine light on jeep liberty diesel
Take it to the dealer and get it reset.
Jeep does not use inertia/reset switches.
Jeep does not use inertia/reset switches.
Jeep does not use inertia/reset switches.
Jeep does not use inertia/reset switches.
There are no adjustments in the transmission on a Jeep Liberty.
You reset it with an OBD2 scan tool after it is repaired.
How can you clean your fuel pump to make it work again
With a scan tool, or unhook the battery for 5 minutes
You reset the codes with a scan tool after repairing the failure.