By passing an electrical current from one pin to the other. The greater the moisture content, the higher the resistance. By measuring the resistance, it gives an estimate of the average moisture content. I think.
2009/03/14 - Correct, but exactly backwards .... Moisture (water) can be a conductor. Dry wood is an insulator. The higher the moisture content, the lower the resistance and vice-versa. Wood with a high moisture content gives a low resistance to the tester and conducts the test voltage better.
An accurate measurement is made with a pH-meter; pH-papers make only approximative determination.
The electrical power that you use from the utility company has to be metered. This is done with a plug in watt meter. The meter socket is what holds the electrical watt meter. It is this meter that the meter reader reads to give you your monthly billing for the electricity that you used.
Depending upon the voltmeter, the 300 volt range would typically be the most correct to give you a mid-scale reading of 120volts.
Kilogram per cubic meter
because able to growth microorganism and give it what he wont to live
humidity meter
You will have a gas meter to give this reading. If it doesn't give cubic feet directly it should have a conversion factor on the meter. So you just read the meter on the right days.
The moisture content can be calculated by weighing the fruit and then placing it in a drying oven for a definite period of time then removing and weighing again. If you continue this until there is no more loss of weight. The initial weight minus the final weight is the weight of water. this difference multiplied by 100 and divided by the initial weight will give you the percent moisture content.
To read the Meralco Meter, take a reading from each of the five dials. The numbers on the dials represent the current reading. Take the digit each dial is pointing at during any particular moment in time, and the combined numbers from the five dials is the reading.
Take the reading in the Energy meter at a particular time and then the reading again after 24 hr. The difference will give you energy consumed in one day.
LABSA reacts with sodash to give the product of sodium salts of labsa and CO2 evolved and water in moisture content.
An accurate measurement is made with a pH-meter; pH-papers make only approximative determination.
The K Factor in Current Transformer Metering is the Multiplyer. The current transformers might be a winding ratio of 200/5 therefore the K Factor would be 40. Meaning for every 100Amps in the meterered conductors only 2.5A is read by the meter the resultant reading is then multiplied by 40 to give the reading of 100A (or the calculated kWh reading for electricity consumption)
A dissolved oxygen meter measures the oxygen pressure in water. An anode is covered with water to halt the oxygen probe in the DO to give a reading.
they give off moisture because tehy go through a method called transpiration.
The water present in the watermelon will give the fruit moisture and will not allow the heat to react with it.
Yes, the Post Office will have this information if you give them the meter number.