Obviously it partly depends on the shower head, but most will give about 2.5 gallons per minute, so you are using about 12 gallons of water, possibly about 8 - 9 of it hot.
Place a 1 liter bottle below the shower and measure how many seconds it will require to fill it. Then:
Number of gallons in five minutes = 78,1/ Number of seconds
An average shower head emits about 1.3 -1.5 gallons per minute, so that would be 7 -8 gallons.
An average shower head emits about 1.3 -1.5 gallons per minute, so that would be 7 -8 gallons.
Obviously it partly depends on the shower head, but most will give about 2.5 gallons per minute, so you are using about 12 gallons of water, possibly about 8 - 9 of it hot.
3 1/2 gallons
4 gallons if head delivers 2 gallons/minute
A shower head would use between 60 to 75 gallons for a 30 minute shower.
6.3 gallons of water us used
depends on how much you want, like i have 700 gallons.
Can't say because this depends on the flow coming out of the shower head. If the flow is 1ltr per minute then in 10 minutes you will use 10 litres The average shower in the US flows at a rate of 7.9 liters per minute, or 2.1 gallons per minute. A ten minute shower would consume 79 liters or 21 gallons of water.
Usually about 2.5 gallons per minute
There is no relationship between millilitres and a shower.You are possibly asking how much water does it take to shower, in that case- the average shower head discharges about 1.5 - 2 gallons of water per minute.
Aim the shower into a bucket. Let it run for one minute. Measure how much water that has collected in the bucket. Now you have the flow per minute. Next, time yourself when you take a shower. Multiply the minutes spent showering with the flow rate to find the total amount of water used.
millions of gallons of water
An average flow rate cannot be determined as there are many different shower heads and each house in every country has different water pressure and not everyone may use full pressure when using a shower. But, approximately said that the average flow rate of shower water 2.5 gallons per minute at a water pressure of 80 pounds per square inch.
25-30 gallons.Depends on the head. Reg. heads about 2.5 per min. x 10 = 25 gal.
A ten minute shower can use less water than a full bath. With a new 2.5 gallon-per-minute (low-flow) shower head, a 10-minute shower will use about 25 gallons of water, saving you five gallons of water over a typical bath. A new showerhead also will save energy — up to $145 each year on electricity — beating out both the bath and an old-fashioned showerhead. To avoid moisture problems, control humidity in your bathroom by running your ventilating fan during and 15 minutes after showers and baths.