220 volt is single phase, so power is the straightforward IxE calculation.
30V X 220A = 6600W = 6.6KW
The formula for wattage is W = Amps x Volts. Without the circuit voltage the amperage can not be calculated. kW = A x V x pf/1000. pf is the power factor.
750 watts per horse power20 x 750 = 15,000 watts / 220V = 68A68 amps at 220 volts
Set a Volt-Ohm meter to Ohms and put the two leads from meter across the fuse. One on each end where the metal is located. The meter should read zero ohms if the fuse is NOT blown.
A 30 volt 90 watt lamp has 3 amps going through it. The series resistor also has 3 amps going through it, by Kirchoff's current law. The voltage across the resistor is 90 volts. With 3 amps, that is 30 ohms. (By the way... The resistor must be rated to carry 270 watts. That is a lot of power for a resistor.)
There are schematics available on the web for about $30 plus shipping and handling.
A Stadard washing machine uses a dedicated 15 Amp single pole breaker. Nothing else should be on the circuit.AnswerThe above answer applies to North America. In the UK, a washing machine is connected to the ring main system using a three-pin plug that requires a 13-A fuse.
My electrician says no, has to be some rewiring.
breakers are rated by wire size, not voltage. the appliance manufacturer will probably specify amperage.
you get a transformer...
The answer to this question is yes. The 30 volt adapter will supply twice the voltage required by the 15 amp appliance. The other thing is that 1 amp is equal to 1000 mA. Even if the voltages were the same, the output current of 1000 mA when 1100 mA is needed, is not enough to supply the appliance.
No !
You need to be more specific about the appliance - dryer or range or air condition- 30 Amp for the dryer, 50 Amp for the range, A/C varies.
yes
Nothing, just plug it in. Although the generator has the ability to produce up to 30 amps, the light will only pull 15, this will allow you to utilize the generator to run other items as well...
A #6 copper conductor will limit the voltage drop to3% or less when supplying 30 amps for 175 feet on a 220 volt system.
Devices are rated by voltage and amperage. If you have a source rated for 600 volts you can use a 250 volt device, but not vice versa.
If it is a 30 amp breaker then it is a 240 volt outlet.
#10 wire is used on a 30 amp service.