What would you like to do?
How much does it cost to replace the engine in a Chrysler Sebring?
The cost to replace the engine in your Chrysler Sebring will range between $2000 and $6000. Replacing with a used engine will be the cheapest and replacing with a brand-new engine will cost the most.
4 people found this useful
Was this answer useful?
Thanks for the feedback!
The average cost for a 2004 Sebring engine is around 1200 dollars.That doesn't include the labor to install if you aren't doing ityourself.
It will cost between $300.00 to $500.00 to replace the rack andpinion on a 1996 Chrysler Sebring. This cost includes labor andparts.
Answer dated 8th March 2012. Chrysler Sebring 2002, 2.7V6 4 door LXi Sedan. I shopped around and surprisingly, the best price I got was from my local Chrysler dealer. The w…ater pump runs off the timing chain and is in an insanely ridiculous place - inside the engine crank-case. The boffins at Chrysler must have been very, very stoned when they approved that particular piece of design genius. Labor charges make up most of the cost due to the pump's horrible location and the time it takes to get at it. Since you will have to spend the money getting to the pump, you would be mad not to change the timing chain while you're there. My car has done 127k on the original water pump, so should be good for at least another 100k now the job is done. My trusted private mechanic's boss quoted be an eye-popping Â£2,088. Chrysler quoted $1,310 including tax. Parts and labor warrantied for 12 months or 12,000 miles, whichever occurs first. By comparison, my wife's Mercury Sable needed a water new pump and that cost $350.00, all in. Ouch. Good luck with your repair!
They are in the rear of the engine. Two can be reached byt two more are between the bell housing and the engine. Not a do-it-yourself job.
The part itself for that distributor $1000.00
I just did it myself last weekend. The parts (Distributor, Cap, Rotor, and new spark plug wires) cost right around $300. I would add $600 to $700 in labor to that. So total ri…ght around $1,000.
That depends on what size tires you have and what quality tires you buy. The tires could be between $80 apiece and $250 apiece.
The price to replace a blown head gasket on a Chrysler Sebring V6should be around $1,000.00. The price can vary depending on whereyou have the repairs made or if you replace i…t yourself.
I printed coupons off the Chrysler website which was for $ 89.00 and took my 07 sebring to the dealer to get a tune up ..try it
$2400 _______________________________________________________________ It depends on which engine you have and in what geographic area your vehicle is located. For a 2.4L eng…ine in the Middle Tennessee Area, the part runs $231 (incl. tax) at Autozone and the labor around $700 at an independent shop to $900 at a dealer. (Of course the dealer would charge more for the OEM part also.) So if you have the 4 cyl., you could get it done for under $1000 here.
Depends on where you get it done but was $365 for me. Yuck!
Usually, yes. A broken rod normally damages the engine block makingrepair impossible. Usually, yes. A broken rod normally damages the engine block makingrepair impossible.
The cost to replace a timing belt on a Chrysler Sebring can varydepending on the area you are in and if you do the job yourself ortake it to a shop. You will have the cost of …the belt and laborcosts for the job if you take it to a shop.
\n. This question does not make any sense. Please rephrase and re-ask.
No, the 3.2L will not fit a Sebring.