I have a Chrysler Cirrus
, and I just got my wheel front passenger side fixed... 208 dollars. I'm pissed
remove rear drive shaft from vehicle.remove large nut ( pinion nut) at front of diff, which is generally hidden when driveshaft is in place.with a bearing puller remove pinion bearing, replace with new one. install new pinion seal. reinstall pinion cover and pinion nut. tighten to specified torgue.reinstall driveshaft check diff oil for proper amount
1. remove rear drive shaft.2.remove diff.cover.3.remove both axles.4.remove carrier case assy.5.remove drive shaft yoke.6.tap pinion gear out of housing with (brass hammer).7 remove pinion seal and front pinion bearing.8.rear pinion bearing well need pressed off & on the pinion gear.9.you need to use a punch drive the bearing race from housing both.
to replace pinion bearing and seal you need to remove drive shaft.you then remove the pinion nut from pinion shaft. u usually need a pretty good rattle gun to remove this .then remove yoke from front of differential.u may need a puller but usuall tapping with hammer will loosen it. remove the bearing and replace with new one then install seal and replace cover and ypke. replace pinion nut, fill with oil.replace drive shaft
could be ring and pinion or a bad u-joint or a wheel bearing
you re rear axle i just replaced mine it probably the front pinion bearing
They very rarely need replacing, just adjusting
Begin by removing the tire and wheel. Remove the and of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install your new wheel bearing.
to replace pinion shaft seal you need to drop the drive shaft from the rear end then with large socket remove pinion nut from front of yoke remove yoke remove old pinion seal install new pinion seal reinstall yoke and pinion nut to specified torque re install drive shaft note now is the time to check and see if U-joints need replacing
to replace pinion shaft seal you need to drop the drive shaft from the rear end then with large socket remove pinion nut from front of yoke remove yoke remove old pinion seal install new pinion seal reinstall yoke and pinion nut to specified torque re install drive shaft note now is the time to check and see if U-joints need replacing
I don't know about making the "CARD" front wheels turn, but the steering gearbox, or the rack and pinion actually cause the "car" front wheels to turn, after the steering wheel is turned. Repairing either usually involves replacing with either a rebuilt, or new gearbox or rack and pinion.
No. The pinion seal would be at the differential input.
how to cahange front pinion seal