Generally speaking the longest part of replacing a fuse is going to the store to buy a new one.
In household appliances the only fuse a user should be replacing is the one in the plug top, and this should take at most 5 minutes.
Remove the plug from the wall, unscrew the center screw from the plug top and open the plug.
The fuse will be clearly visible. Use a screwdriver or something small to pop out the broken fuse. Replace with a fuse of the same rating. Replace the plug cover reinsert screw and your done.
It should be noted that a blown/ broken fuse is usually (but not always) indicative of a problem in your device (sometimes fuses blow for no apparent reason)
. If this new fuse blows within a relatively short period of time it should be taken as confirmation of a problem with the normal working of the device and an electrician should be contacted.
Open the dashboard fuse panel and look for the fuse marked cig ...replace it
You may need to replace the 4x4 engager switch or replace the fuse in your fuse box.
If there's no indication on the fuse box of what goes to what, check the service/information book for your car. If you don't have that, then take a fuse out at a time, and look for a burnt one until you find it. Make sure to replace it with the same amp rating.
About an 8 hour job.
Very time consuming job. It takes what it takes.
Not easily and it is very time consuming. Depending on the vehicle you are working on. You must take the head cover off then take the cam shafts out that should let you see the pistons. You must then (not all the time but very very likely) take the engine completely of your car. Take the pistons you wish to replace and replace them then put it back together. The Manuel for your car will explain in much much further detail.
Nonfunctioning door locks and security system can because by a bad fuse. Replace the security system for use with a new fuse. Most of the time this will fix the problem.
You could, but it would be safest not to. A time delay fuse will allow for a short (12 seconds or less) spike in the current (up to three times the rated current for the fuse). This happens when you start up a motor, or a compressor, etc... If you were to replace a regular fuse (say 2 amp) with a time delay fuse (also 2 amp), then instead of breaking the circuit at 2 amps, the circuit will go 12 seconds at 6 amps before shutting down. This could easily start a fire, so for your safety, it is best to replace a fuse with the exact same kind that came out of it.
believe it or not it is under the hood, no one could help with this and that fuse blows all the time
hi: i take a tester and while car is off . i ground tester and check one fuse at at a time to see which one does not light up( test light should come on if fuse is good.) look for one that is blown,it be melted inside . replace and blow horn. ron
I have to pull a fuse to get mine to work and then replace it. It only works once, so every time I want in the hatch, I have to open the hood, open the fuse box, remove and then replace the fuse. I can then open the hatch once.
Short or incorrect size fuse. Make sure you are installing the correct fuse. If so, look for a short in the wiring.