0
Its easy, grab the front part of the seat cushion, pull it straight up, there are two clips, one on each side, that will unclip without breaking, when you pull up. Then there is one loop at the back of the cushion that must be pulled forward and slightly up, this part can be a bit challenging, but with enough force it will slide off. It may help to squeeze your hand back to the loop and pull from there, if your rear seats fold down, that can also help.
Getting it back on is easier than removal.
Once the seat is removed, you will have access to the fuel tank (from above) where the fuel pump and filter are located. If you are changing the filter and pump, be extra careful to install all rubber o-rings or the job will fail. The shop manual says you should replace them, so that is recommended, but you can carefully remove them from the old and reuse if you do not have replacements.
Wiki User
∙ 13y ago
John Duffin
Add your answer:
Earn +20 pts
How do you remove rear seat of Toyota Corolla?
The type of the rear seat of the Toyota Corolla will determine how you will remove it. For instance, for a folding seat, all that you will need to do is to lower the seat to gain access.
Where is the fuel pump in the Toyota Echo?
In the petrol tank , remove the rear bottom seat , you should see an oval shaped plate , remove this with a flat screwdriver , and you should see it
How do you remove back seat on 2002 Toyota Echo?
To remove the back seat cushion of a Toyota Echo (any year) simply grasp the seat between the cushion and body of the car and give it a good hard pull straight up. You will have to do this once on each side then again for the middle back of the cushion.
How do you remove the rear seat on 2007 Toyota Camry?
How do you remove seats in a 2007 Camry SE
How do you Remove passenger seat from Toyota Echo?
Its included in the following instructions for changing out the post cat O2 sensor. http://www.carspace.com/guides/Toyota-Echo-How-to-change-post-catalytic-O2-Sensor
How to replace seat belt in Toyota Echo?
take it to the Toyota dealership and ask them to replace it
How do you remove rear seat from 1997 Mercury Villager?
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
How do you remove rear seat in 2003 Toyota Corolla?
Go to the nearest mechanic he'll help you out :D LOL
How do you remove the rear cup holder on a 1998 Corolla LE?
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
How do you remove the rear seat of a 2001 sonata?
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm
How do you remove the rear seat on the 1997 Mercury Villager?
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
How do you remove the back seat of a 1998 Toyota Corolla?
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
