Removal.
Roll glass down.
Disengage two clips attaching speaker grille to door trim panel.
They are at the front of the grille, one near the top, and the other one at the bottom.
Remove three large washer-headed screws surrounding the speaker (lower door trim panel removal).
Remove access cover at front of door trim panel. Remove by prying at its rear edge (mirror bezel and door trim access cover).
Remove red courtesy reflector from lower tail or door. Disengage by prying at screwdriver notch at bottom of reflector.
Remove flag trim panel from door by prying off at two attachment clips points (mirror bezel and door trim access cover).
One screw located at lower rear screw pocket.
Three screws located along bottom of door.
One screw located inside handle opening.
One screw located at the upper front.
One screw in the pull cup.
Disengage two hidden clips attaching at the rear of the trim panel, by prying off at two attachment clip points.
Lift trim panel upward and away from door, diengage trim panel from upper retainer channel.
Diengage clip attaching latch linkage to back door handle.
Disconnect electrical connectors as necessary, including lower foot light, if equipped.
Remove door trim panel from door.
how do you remove the door panel on a 2001 dodge stratus?--2 door
It is under the dash on the driver side. It is on the backside of the dash fuse panel.
Open the drivers door, remove panel on left side of dash. This panel is covered when the door in closed.
No.
The 2002 Chrysler Sebring OBD 2 port is underneath instrument panel, near steering column
Trunk is open.
The 2001 Chrysler Sebring OBD 2 port is underneath instrument panel, near steering column
fuse panel left side dash panel
2000 Chrysler sebring,to replace battery car must go to dealer to have fender removed so new battery can be installed, they charge $169.00 for this work. Or they remove it through the hatch in the wheel well. Turn wheel fully left. Disconnect terminals. Remove the panel from the left wheel well. Remove the battery hold-down
Dealer, salvage yard, etc
under the hood in the fuse panel i believe
Remove door panel where switch is located. Remove itch. Use fine emery board nd clean points. It worked for me