No they shoud be right next to each other in fact dump bucketloads of cold water on the hot water pipe cuz thats a good idea okay just do it lolz
Whether the pipes and wiring are chased or not. A minimum distance of 200mm is recommended. Making sure that the water pipes are always underneath the electrical wiring.
for pipes up to 2" it is 1/4" fall per foot
It depends on what the pipe is for. Domestic water pipes run between 30 -70 psi in general.
It depends on what the pipe is for. Domestic water pipes run between 30 -70 psi in general.
There is no exact figure that can represent the distance between two tubewells. It depends upon the underground formation if two tubewells drilled at a distance of 100ft. and both sharing the same low water bearing aquifer then the discharge of one will effect the discharge of the other well. Distance should be as far as it could be, atleast more then 400ft. (minimum side) Farhan
Why is the second paragraph a contradiction of the first? If hot water pipes 'Absolutely' do not freeze faster than cold water pipes then why the comment about the cold water pipes having a larger diameter which causes them to freeze at a slower rate than the smaller hot water pipes? Also, the word then in the last line should be thanand there should be an a between usually and larger. And, piping should be changed to pipe.
Lag
For 100mm pipes, the type normally used for residential drainage, the minimum acceptable falls are 1:40 for Foul Water and 1:100 for Surface Water. Larger diameter pipes may have gentler gradients in certain circumstances.
3 yds
The distance between Na+ and the oxygen atom of water is about 2.4 Angstroms.
Lag
A plumber installs water pipes.