0
This is called a bayonet. They are commonly used in the game Call of Duty world at war. Iget stabbed alot by them. And they show up as a gun kill....i'm like...he knifed me!!!
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What are long steel knives attached to the ends of guns called?
Long or short, they are known as Bayonets.
What is the name of the knives on the ends of guns?
The knife on the end of a gun is a bayonet.
What is the only muscle attached at both ends?
With the exception of the tongue (the heart is a special case), all muscles are attached at both ends
Which muscle is not connected at both ends?
The tongue is a muscle that is not attached at both ends.
What spring pushes the object attached to its ends?
Vertical
What are drawing knives used for?
Draw knives are used for shaping wood. Two specialized draw knives are spoke shaves and inshaves for carving wooden wheel spokes and hollows, these are curved. Most draw knives are flat blades with handles on both ends, and drawn toward the carver to remove material.
Why are the ends of many bridges not attached to bridges?
When you finally reach dry, flat land there is no need for a bridge. So many bridges are attached to roads and railways instead, often at both ends.
How much weight will a four inch tall X 2 inch wide with a one quarter section steel tube five foot long supported on both ends hold in the middle without bending?
That depends... on the composition of the steel !
Where are the spark plugs on 1999 Toyota Tacoma V6?
they are attached to the ends of the spark plug wires
How do you make fire with steel wool?
use the steel wool to complete the circuit on a 9 volt battery. Touch it to both ends of the battery at once and it will spark, have kindling nearby to be lit by the steel wool.
Distal and proximal ends of long bones?
The epiphyses are the distal and proximal ends of long bones
Replace auto trans cooling hose on Mercedes 190e?
Remove the plastic panel under engine and radiator. Locate the coolant hoses attached at radiator and steel lines mounted at the engine. The lines should have steel coil springs over them. Lubricate the connections with WD40 or equivilant product at each end. Using a 17mm wrench hold the steel tubes at each end while loosening the hose end with a 19mm wrench. Be careful! The steel ends will break! Replace the lines and check transmission fluid level (some will leak during this process).
