0
Put new fuel pump and filter on a 1998 chrysler cirrus but cant get gas through line to injectors?
Wiki User
∙ 15y ago
when you turn key to on position but not to start you should hear a humming for a couple secs if you do not hear the humming from the fuel pump then check the relay in the power distribution center under hood if you remove the cover for the distribution center and look inside the cover it gives a diagram of where the relays and fuses are located and what they are for. locate the fuel pump relay and when turning key on listen for it to click if it doesnt than that is probably the problem but also look for any fuses in the box that say fuel and check them too. If it worked before you replaced the pump you may want to retrace your steps and recheck all the wiring at the fuel pump or damage to any grounds.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the cabin filter located on cirrus?
A Chrysler Cirrus does not have a cabin filter.
Where is the cabin air filter located on a 2000 Chrysler cirrus?
A 2000 Chrysler Cirrus does not have a cabin filter.
Where is the cabin filter on a Chrysler Cirrus?
It does not have a cabin filter.
Is there a cabin filter on a 1999 Chrysler cirrus?
No
Does a Chrysler cirrus 1995 have a air condition filter?
no.
Is there a in cabin air filter in a 2004 Chrysler cirrus?
No.
How do you change the cabin air filter on a 1999 Chrysler cirrus?
It does not have a cabin filter.
How do you replace the cabin filter on a 2000 Chrysler Cirrus?
It does not have a cabin filter from the factory.
Where is the power steering filter for a 2000 Chrysler cirrus?
It does not have one.
Where is the fuel filter on a 1997 chrysler cirrus?
The fuel filter on a 1997 Chrysler Cirrus is located above the gas tank. It is in the fender wall just ahead of the rear cross member that holds the two rear fenders together.
Where is the fuel filter on a 1995 chrysler cirrus?
on the top of the gas tank, you will have to put the tank down so you can replace it.
Does the fuel injectors on a 91 3.0 Chrysler have to be bled after the fuel filter has been changed?
No, the system is self priming.
