pull the wheel off remove the brake caliper and disc. there might be a cap in the center of the hub. if so remove it and there will be a single nut coming from the spindle remove it and the the whole assembly will come off.
assembly manual off eBay
On under the hood on the driver's side of the car right behind the headlight assembly.
1984 brogham98
If this is a RWD Cutlass Supreme, ask the question again as:"How do you replace rear axle bearing on olds cutlass supreme?"Otherwise, remove the rear brake rotors and calipers if 4 wheel disc, drums and shoes if rear drum.Disconnect the rear wheel speed sensor electrical connector if 4-wheel ABS.Unbolt the four bolts holding the hub and bearing assembly to the spindle. I believe you will need a t45 or t50 socket. If you don't have a socket of the appropriate size, buy one. Remember that cheap sockets ruin bolts and ruined bolts ruin days.Use a hammer (about 1.5 to 2 pounds) to knock the assembly free. Hit it on the left side, right side, top, and bottom alternately.Use a bit of grease to ease reinstallation.
Stick the starter in the cutlass supreme.
Oldsmobile Cutlass Supreme was created in 1966.
81-86 are the same. 87 is the same as the 88 supreme classic. 87 grills will NOT fit an 86 without changing the entire header assembly.
Where is the water pump on a 1995 olds cutlass supreme?"
How do you replace a axle on a 95 holds cutlass supreme
factory colors of oldsmobile cutlass supreme
what are the steps to take off transmission from a Oldsmobile cutlass supreme
supreme luxury.