i hope you are replacing them not just removing them as you wont get too far without them
Front or rear?
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearings.
The front wheel bearings, of a Pontiac vibe, can be replaced by first removing the front wheel. Next, remove the axle end cap. Remove the bearing and reverse the process to install the new bearing.
they are replaced as hub assemblies, remove the wheel, remove the caliper and rotor three bolts for the hub, axle nut, abs harness if the car has it, and remove the hub assy
Remove the tire and wheel from your 2001 Chevy Impala. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new front wheel bearing.
In most cases wheel bearings cannot be repaired and must be replaced. Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearings. Reverse the process to install the new wheel bearings.
Remove the tire and wheel from your 1997 Chevy Astro. Remove the axle end. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new front wheel bearing.
No, bad front wheel bearings would not prevent a transmission from shifting. If your car has bad front wheel bearings you will notice wheel noise or wheel looseness.
Purchase new hubs complete with pre-greased bearings. (About $160.00 each). Remove caliper and disc. Remove old hub. Replace new hub, disc and caliper. Voila!
there are a total of 4 wheel bearings on the front both sides have an inner and outer bearing. the outer bearing is visable when you remove hub the inner bearing is visable when you remove rotor
They need to be pressed in. You will have to remove the hub assembly and have a shop press the bearings into the hub.
Remove wheel, remove the brake caliper and brake pads, Pull the dust cap. remove cotter pin. remove nut and washer. tilt the rotor back and forth to pop the bearings (front) remove rotor and pop the back bearings. This would be for a 2 wheel drive S-10.