Could be a drain for the inducer motor if it has one and it depends do you have a a/c coil on your furnace if so it could be a drain for it.
Several things come out of blast furnaces. They are listed here: 1) A molten version of whatever material was put in it to begin with, 2) Incredible heat, 3) Powerfull light, 4) A waste gas and usually some slag remnant of the fuel that powers the furnace.
Solar panels are divided into two main types depending on the energy they gain - electrical and heat. Obviously this one is gaining heat energy and that is why it has pipes connected to it.
Sweat a female fitting on the copper or use a compression coupling between the two.
no
There will be the connection to the sewer and the drain coming out of the house. Connect the two with PVC at the proper pitch. 1/8 inch fall per foot of length.
Simple. Rip out the old and relay with PVC using good quality piping. Where you need to join to old fittings and new there are joints that marry the two.
You get two PVC pipes that gk to your belly buton both look like this at the end duct tape together and your done it will bounce hi
The simplest way: * Use closet poles and PVC elbow joints to make a rectangular frame. It should probably be the same size as the mattress. * Hang the frame from the ceiling using eyehooks and strong fishing line. A somewhat more elaborate route is to use all PVC, and construct an entire canopy bedframe. You can get order furniture-grade snap-together PVC pipes and fittings from a company like Simplified Buildings Concepts (http://www.simplifiedbuilding.com/), or from a well-stocked hardware store. * Use 7' pipes for the vertical supports. * Use pipes that are just slightly longer than the dimensions of your mattres. For example, a queen mattress is 60" by 80", so get two 62" pipes and two 82" pipes. * Use the Three-Way-L fitting to connect them all together.
Electric base board heater and gas furnace.
SWR pipes are used for drainage systems and are made of a special type of PVC material that is resistant to chemicals and high temperatures. uPVC pipes, on the other hand, are used for water supply systems and are made of unplasticized PVC material that is strong and durable. The main difference between the two is their intended use and the type of material they are made of.
Read the label. A gas heater will have three plumbing pipes connected.One is a gas supply. An electric heater will only have two plumbing pipes but it will have an electical conduit or electrical wire feed line.
You can not glue brass directly to PVC pipe. Use male/female adapters to join these two materials. ie, a male threaded PVC end fitting glued to the PVC pipe and a female threaded brass fitting screwed onto that.
A few places offer parts for gas furnaces. Sears and Lowes are two places that offer these parts. Among them, you may be able to buy certain furnace parts at you local heating and cooling company.
Poly Vinyl Chloride is made from two main ingredients. These ingredients are chlorine and ethylene both of which are needed to make PVC conduit . UV inhibitors are also added to the ingredients to prevent degradation from exposure to the sun's rays.
It could have any size heating furnace, the two are unrelated except for the size blower used in the furnace to support the 3 ton cooling system. But the fact remains you can get a 3 ton blower in 50,000 btu furnace, a 100,00 btu furnace and anything in between.
Yes. Specially if you have a 90%plus condensing furnace. This furnace has two heat exchangers, which means that it uses the combustion chambers radiant heat as comfort heat, if the furnace is matched with a 2 stage or modulating gas valve, the savings can be between 40 to 60 percent savings on utility cost.
what are the two pipes in the throat called