Take a sample to a pool store with a "water chemistry certified" tech. They can tell you exactly what is missing. Normally pools need stabalizer, chlorine, acid and soda. Extra chems are used to rid or avoid problems
You will need to add an amount of chemicals that is proportional to the size of your pool. The containers of the chemicals should tell you how much to add for the size of pool you have. It might be better if you take a sample of water to a local pool supply store, so that they can tell you exactly what you need for your specific pool. http://www.ehow.com/about_5390392_chemicals-put-new-pool.html
Are you talking about a pool? Or a Hot Tub? For a pool you need Chlorine, algae remover, and a pool disinfectant. I use a disinfectant called Kikz Pool cleanser and disinfectant.
To raise the pH of your pool you add soda ash (sodium carbonate). To lower the pH of your pool add muriatic acid (hydrochloric acid) or sodium bisulfate. You should always add chemicals with the pump running and check your levels again once the newly added chemicals have been circulated around the pool.
no. there are "natural pools". but if you want the classic clean blue pool, you have to.
using a Copper Silver generator to control algae and bacteria will lower the other pool chemicals so you have a lot less problems from the chemicals. So I would run this generator first for a day or two and then test the water to figure out how much you needed to add as to water testing kit specs. http://www.sunshinepool.com/ion2.html is one company that makes them BUT there are a lot of others (just Googled for siver/copper pools and you can find others (this one also has zinc
You will need to add an amount of chemicals that is proportional to the size of your pool. The containers of the chemicals should tell you how much to add for the size of pool you have. It might be better if you take a sample of water to a local pool supply store, so that they can tell you exactly what you need for your specific pool. http://www.ehow.com/about_5390392_chemicals-put-new-pool.html
You shouldn't add chemicals to a pool in which people are swimming. Add the chemicals, ensure that you've made the correct adjustment to the water chemistry and that the water is safe, and then allow people back in. To be honest, it probably wouldn't hurt them - but it wouldn't be wise.
You can add some kind of herbs to the pool.
Most authorities advise adding chlorine (and other chemicals) in the evening. I would not add any chemicals during the hottest part of the day or when the sun is beating down. Most people prefer to add pool chemicals at night after they're through with the pool so the chemicals can work overnight.
Add rain water this has very low alkalinity
Reduces alkalinity of swimming pool water (softens hard water)
Yes you can. This sometimes may be dangerous. If you do this, make sure nobody swims for the next few hours.
You can purchase testing strips which will indicate your pool water's levels of chlorine, pH and so on. With this information, you can determine which chemicals you need to add, and in what amounts. Visit a pool supply store to get the supplies.
Are you talking about a pool? Or a Hot Tub? For a pool you need Chlorine, algae remover, and a pool disinfectant. I use a disinfectant called Kikz Pool cleanser and disinfectant.
To raise the pH of your pool you add soda ash (sodium carbonate). To lower the pH of your pool add muriatic acid (hydrochloric acid) or sodium bisulfate. You should always add chemicals with the pump running and check your levels again once the newly added chemicals have been circulated around the pool.
It is necessary because the chlorine kills all of the germs that enter the swimming pool.
as soon as you put the water in you can ad chemicals to it