0
An in-line fuse.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you hook up ele plug in wires coming in to house the plug has white black and ground wires and the wire from the house has white black red and ground hooked to a 30amp fuse?
You will have to check to make sure. Normally, with 4 wires, the black and red are both power for 220. White for neutral and bare for ground. If you are only using one leg of it, you would use the black, white, bare ones and cap the red one. Someone may have used the 4 strand because they had it or 220 was planned but not done or both the red and black are hot. You should be able to tell in the panel. Do the red and black both connect to separate breakers or to one or is the red not connected?
If a oversized fuse is used instead of correct fuse what could happen to the fuse?
If you oversize a fuse you run the risk of overloading the wires that are part of the circuit you're trying to protect. Once the wires are overloaded, heat is generated and eventually you could have an electrical fire. The oversized fuse would trip at a higher amperage then what is required to properly protect the circuit. Always use the right size fuses or you run the risk of serious damage, injury and even death.
What wires do you hook up to the fuse box when wiring a hot water heater?
You're scaring me! Get an electrician!
How are black cat fireworks made?
They are flash or black powder compact with cardboard and a fuse
Can you replace an 8amp ceramic fuse with a 10 amp ceramic fuse?
Any electrical engineer, electrician, fireman or anyone else who understands the function of a fuse will advise strongly that you NEVER replace a fuse with one of a higher amperage rating.Fuses protect wires from overheating. The original fuse is matched to the capacity of the wires and other components of a circuit. When a properly matched fuse is replaced with a fuse of larger capacity you place your home, office, automobile or other property in jeopardy. The risk of a fire becomes very high when you use an over-sized fuse.If you have any questions, consult with a competent electrician or electrical engineer.
Where is the Circuit Opening Relay Toyotoa Tercel 1996?
attached to the side of the fuse box under the drivers side dash. has 1 large black/red wire, two smaller black/red wires, a light blue and a green wire, the green and blue have stripes too just dont remember what color.
What happens if you incorrectly connect old black wire to new white wire?
If the wires are incorrectly connected the idea is that it will blow the fuse.
Show you the fuse's diagram on the engine of the 2000 GMC safari?
It is under the fuse box cover which is under hood, on driver's side. It's the box with all the wires going to it! It is under the fuse box cover. the fuse box is under the hood on the driver's side just above and to the side of the battery. It's the black box with all the wires going to it.
What happens in spinal instrumentation?
During the fusion operation, a set of rods, wires, or screws will be attached to the spine. This instrumentation allows the spine to be held in place while the bones fuse.
What do you call the part that is attached to the positive battery cable that looks likje a fuse on a 2003 mercedes benz ml500?
Fusible Link
Where is the fuse on a Cub Cadet LTX 1046?
I just changed mine, and it is under the seat. Remove the battery, and then there is a relay that is screwed to the inside of the back of the tractor under the battery compartment. Unscrew that relay and the fuse is attached to the wires coming out of that relay.
Where is the location of the Wiper Motor relay for a 97 Accord?
The wiper relay is located under the fuse panel in the engine compartment. It's attached to the underside of the bracket that holds the fuse panel in place. You have to disconnect the pos and negative from the fuse box and one little clip with 3 wires.
Which metal used in fuse wires?
Apparently mainly tinned copper is used in fuse wires. I have heard that there are a lot of other metals used as teh fuse wire though!
Where is the flasher unit located on a 1993 Ford Probe?
The flasher unit is located up and behind the fuse box. It is black with a socket that has @ 10 wires into it.
How do you replace the 100 amp alt fuse for a 2000 Toyota Camry?
100 AMP Fuse ReplacementNot sure , but if your talking about the 100 amp fuse in the fuse box under the hood,,here goes.... Assuming you already have the fuse box cover off,,,,remove the battery to get it out of the way,,,remove the two bolts holding the fuse box ,,,the bottom of the fuse box comes off by depressing on each side near the bottom,, locate the large black and white wires that go into the fuse,,you'll need a screw driver to un-lock the fuse and fuse holder,,pulling slightly on the wires while depressing the latch ,,it should come out from the bottom,,,the two wires are bolted on to the fuse, remove the bolts and the fuse should slide out of the fuse holder,,,install new fuse,,bolt the wires back in place, insert the fuse and fuse holder back into the fuse box, replace the bottom of the fuse box, rebolt to the car,,re-install battery...New fuse cost about $10 from Toyota Dealer.If this is not what your asking for,,maybe it will help someone else.
Where to get a fuse box diagram for a Lexus 1998 gs300?
I need a fuse box diagram for a 1998 Lexus GS 300. What is the site for a diagram with more in detail? I need to understand what each fuse does, also there are black square glass fuses attached to the fuse box. What do they control in my car...
How do you remove the 60A ABS fuse on a 1992 Toyota Camry?
We have a 1995 Camry and the fuse box is located on the right handside if you stand in front of the car, you have to unscrew the bolts that hold the fuse box (its the one near the front of the car) and then turn if over you will find that the fuse has wires attached to it the same as the 100amp fuse in the front, then unscrew the bolts that hold the fuse in place and it should just come out by pulling on it. Hope this helps
