what does the code p-1525
1525 is the vent solenoid circuit. it usually is with 1526(vacuum) and 1540(abv). there are a bunch of answers to this, and this problem is very common in the 2.3. sometimes, this is also accompanied by the car going "limp home". tcs off/tcs lites come on, and car wont rev over about 2500. it feels like fuel cut. there is a row of 4 solenoids right next to the egr valve. the vent is the second one, the vacuum is fourth. you should change both. some will say first check the vacuum lines, and they can be a problem, too, but i am sure it is the solenoid.
i need a diagram to show me how to remove a starter on millenia s 1999 mazda
The 1999 Mazda Millenia OBD 2 port is on lower right corner of dash; next to tunnel
on a 2.3, it is behind the radio, and is not easy to remove
Should be a 15" wheel. My 96 was.
2.5L V-6 Mazda Millenia engine is a non-interference engine. If your timing belt pops, you will not damage your valves, like I did in my Diamante
It is in the Trunk up by the back seat
call your local dealer
Possibly a vacuum line came undone
Well if it's supercharged, its the 2.3L. If it's the non-supercharged, then its the 2.5L.
Because you have a short in your steering column wiring.
driver door panel........near bottom i know awkward place.
Trouble code P0720 means: Output Shaft Speed Sensor Circuit