A bright flash and a dud bulb, possibly a blown fuse instead.
It should be ok
temporary it blows or KABOOOMM....
zzzzzzzzzzzAAAAAAAAAAAAAAAPPPPPPPPPP !!!!!
When equipment is run at a lower voltage than it is designed for, it does not operate correctly. A light will glow dimly or not at all, a heater produces much less heat. Electronic equipment may not function at all.
First, someone would have changed the plug before that would be possible. 240 Volt receptacles do not accept 120 Volt plugs. Second, IF someone changed the plug on the compressor, then plugged it in using both legs of the 240 Volt circuit, the compressor motor would self destruct instantly; internal wiring would burn and you would smell the burning insulation.
lamp works on power of volt
It'll only deliver 1/4 of the power.
If your supply voltage is 120 volts the impact of switching from a 145 volt lamp to a 130 volt lamp would be, the 130 volt bulb would not have the same lifetime as a lamp operating on 145 volts. The upside would be that the light output would be greater. This is based on both of the lamps having the same wattage rating.
No, the bulb would last about 5 seconds... if that.
If the ballast of the HPS fixture has a 120 volt tap then, yes it can be plugged into a 120 volt receptacle.
Not much of anything. The 220 volt appliance needs just that ... 220 volts in order to run. If it runs at all, it certainly would not be running at anywhere near peak efficiency.
If it is an incandescent lamp, then it will run on 240volts, but not at full wattage. If it is an HID type that has a ballast, no, it will not.