It'll only deliver 1/4 of the power.
To hook up a 120 volts outlet, use a new outlet that is a protected type. It must be GFCI or be wired into a GFCI-protected circuit in an unfinished basement, bathroom, or garage that has damp areas.
In US household electrical service there are two "hot" 110 volt wires and one ground. Only one hot wire is connected to a normal outlet or light fixture. To wire a 220 volt alternating current outlet, both hot wires are connected to the outlet. This is used for appliances that need more power than is provided by 110 volts like electric ranges, clothes dryers, air conditioners.
Usually, radios have a slot at the back or bottom where you can insert batteries (Often AA). If it does not have a slot, and isn't solar powered or anything, then contact the radio manufacturer, who will tell you how to use batteries. If the radio has to be plugged into a socket outlet and has no slots for any batteries, then the only way you can use batteries to supply it with power is to use an electronic power inverter unit. Several types are available. The most common can use a 12 volt battery and has a socket outlet into which you can plug the radio.
Graybeard's dead, Volt is tao's father, and Tao defeated the saxon
There is one out of six chances that you will feel a current draw.
zzzzzzzzzzzAAAAAAAAAAAAAAAPPPPPPPPPP !!!!!
No, a 1500-watt electrical heater should not be plugged into an 110-volt outlet in an apartment. The heater requires more power than the outlet can provide, which may overload the circuit, pose a fire hazard, and damage the electrical system. It is not safe to use appliances that draw more power than the outlet can handle.
If the ballast of the HPS fixture has a 120 volt tap then, yes it can be plugged into a 120 volt receptacle.
It should be ok
Nope. Unless you wanna burn up your speaker.
Yes, a 110 volt device can be plugged into a 125 volt receptacle. The voltage rating on the receptacle is only there as the highest voltage supply that the manufacturer recommends their equipment be connected to.
temporary it blows or KABOOOMM....
The device requires a 250 volt 20 amp receptacle, which is typically a NEMA 6-20 outlet.
The device requires a 15 amp 220 volt outlet.
A device that needs to be plugged into a 10-30R outlet requires a 240-volt electrical supply with a maximum current rating of 30 amps.
NOCan however be powered by a 120/ to 12 volt DC power supply plugged into wall socket. (Ensure the power supply has sufficient current rating to run the subwoofer)
No, the Norelco 905RX is designed for 110-120 volt outlets and should not be plugged into a 220 volt outlet as it may damage the device. It's recommended to use a voltage converter or transformer that is suitable for your particular device in order to safely use it with a 220 volt outlet.